9 Inch rear Install


The factory 10 bolt rear before the removal process began. Its a stock "C" clip 28 spline unit with new 3:73 gears and a posi unit.


Just after the rear was removed from the car. Once out I also installed the 3" tailpipes.


The 10 bolt on the ground.


The new Quick Performance Ford 9" rear awaiting installation. It has a Strange center section with 3:90 gears and a spool. Connecting this to the wheels are 35 spline Moser axles with 1/2" wheel studs.


The housing installed. Along with the tailpipes.


Drivers side view.
I boxed the stock lower control arms, added polyurethane bushings and had the housing and control arms powder coated gloss black.


Passengers side view.
While it was all apart I also installed new springs and shocks.


The install almost completed.
Just need to get a new drive shaft made up, finish the brake lines, and adjust the exhaust pipes.
I had a new drive shaft made by The Drive Shaft Shop. Its 3" .083 wall DOM tube with 1350 Spicer u-joints.


Cutlass Page 1

Cutlass Page 2

Cutlass Page 3

Cutlass Page 4

Cutlass Page 6

Cutlass Page 7

Home Page